Create an agent wallet
Three steps, about two minutes. Your agent gets its own wallet on Robinhood Chain, with limits you set. Each step costs a few cents of network fees (gas), paid in ETH.
- 1 · Name it
- 2 · Add money
- 3 · Limits & plug in
Step 1 · Name it
Pick a name for your agent. Then we make its key — a secret password only your agent uses — and deploy its wallet. One click deploys the wallet: the factory builds the Safe, sets you as the owner, sets your backup key, and switches on the agent key.
Use a different address from your connected wallet, and keep it somewhere safe and offline. Never use an address someone else controls.
The agent key — made in your browser, shown once
This key is made on your device and never leaves it. Polypad never sees it, never stores it, and cannot get it back. If you close this page without saving it, the key is gone — the wallet and its money stay safe, but you must give the agent a new key later.
Be honest about the limits
- The 1,000 POLYDASH registration bond is worth about $0.0003 — it stops spam, it is not insurance and it does not pay you back if something goes wrong.
- These wallet contracts have not been checked by an outside auditor yet (automated checks only). The wallet itself is built on Safe, which is audited and battle-tested — but the new session-key module and factory are new code. Only put in what you can afford to lose.
- Gas is still paid in ETH by you. There is no sponsored gas in v1 — keep a little ETH in the wallet so your agent never stalls.
- The wizard never asks for a seed phrase and never asks you to paste a private key. Wallet creation happens only on polypad.family.